Due to being a family run company and personal circumstances, no phone calls or emails will be answered today the 18th of July. We will be back to normal on the 19th of July.
Sorry for any inconvenience caused.
Want to print at high temperatures than 300ºC and also have more accurate readings? Then the PT100 amplifier board is your answer, it will allow a sensing range up to and beyond 400ºC, the maximum safe temperature of an all metal hotend.
This board allows you to simply connect a PT100 temperature sensor to a standard analog input pin on a 3D Printer controller board. The board amplifies the signal from a PT100 sensor to a voltage level which can be easily ready by a 3D printer controller. To use the board simply select temperature sensor '20' in marlin firmware.
Note: HTML is not translated!
Rating: Bad Good
Copyright © Ooznest Ltd 2018 - All Rights Reserved