From the 25th - 28th September, some of the Ooznest team are at the TCT Show 2017. Due to this there will be some delays in answering phoncalls and emails. During this period the best way to contact us would be by email. However we promise to get around to everything, it just may take longer than usual. Thanks Ryan Lock - Ooznest.
Using a bowden adaptor is a very tidy solution for bowden based 3D printers. A bowden adaptor easily converts a direct drive extruder, that normally accepts a groovemount hotend, into a bowden extruder. The E3D bowden adaptor mounts like a hotend, but accepts PTFE Tubing, just like a pneumatic coupler.
Using one of these is a neater solution than a pneumatic coupler, because you no longer have to force thread a coupler into a printed mount. Instead you can use your existing extruder setup.
Note: HTML is not translated!
Rating: Bad Good
Copyright © Ooznest Ltd 2017 - All Rights Reserved