From the 25th - 28th September, some of the Ooznest team are at the TCT Show 2017. Due to this there will be some delays in answering phoncalls and emails. During this period the best way to contact us would be by email. However we promise to get around to everything, it just may take longer than usual. Thanks Ryan Lock - Ooznest.
Want to print at high temperatures than 300ºC and also have more accurate readings? Then the PT100 amplifier board is your answer, it will allow a sensing range up to and beyond 400ºC, the maximum safe temperature of an all metal hotend.
This board allows you to simply connect a PT100 temperature sensor to a standard analog input pin on a 3D Printer controller board. The board amplifies the signal from a PT100 sensor to a voltage level which can be easily ready by a 3D printer controller. To use the board simply select temperature sensor '20' in marlin firmware.
Note: HTML is not translated!
Rating: Bad Good
Copyright © Ooznest Ltd 2017 - All Rights Reserved