Electronics Manual Coming Soon...
To clarify the Z Travel, this is not the max cutting depth or the travel range of the actuator. Z travel is the distance downwards it can travel before hitting the spoiler board supports.
The WorkBee has two spoilerboard support configurations. One with a travel of 66mm, and a lower one with a travel of 106mm. The reason for the two configurations is that if the machine is always used to cut thin materials, for accuracy reasons it is better to have the work piece as close to the Z-Actuator as possible, so in this case the machine should be setup in the higher 66mm travel configuration.
The higher configuration has a Z travel of 66mm, with a 12mm spoiler board, this will reduce the Z travel to 54mm. In this case 54mm is maximum thickness of material that will fit on the machine.
To calculate the max cutting depth for a chosen piece of material it is:
Max Cutting Depth = Z travel – Material Thickness
For instance a setup with a 12mm spoiler board, the max Z travel is 54mm, so when cutting into a material 30mm thick the max cutting depth would be:
Max Cutting Depth = 54 – 30 = 24mm
This means with a 30mm piece of material it would not be possible to cut it the whole way through.
The max thickness that can be cut the whole way through is half the Z travel. So with a Z travel of 55mm, 27mm is the maximum thickness of material that could be cut the whole way through. And for the lower configuration the maximum thickness that can be cut the whole way through is 47mm
Note: HTML is not translated!
Rating: Bad Good
Copyright © Ooznest Ltd 2018 - All Rights Reserved