Hall Effect magnetic endstops are a precise non-contact proximity sensing device. The hall sensor provides an analog signal that is proportional to the magnetic field strength. A potentiometer on the Hall Effect endstop allows for sensitive range setup, the analog signal is compared with this value.
These Hall Effect endstops are 32-bit ready, meaning they receive a +3.3V input and output a +3.3V signal, and are plug and play with our RADDS v1.5 controller board. Additionally they can also operate at +5V.
A small magnet is included with the endstop. The endstop has 3 pinouts as follows:
1. VVC (+3.3V or +5.0V)
RADDS User Guide - Download
Note: HTML is not translated!
Rating: Bad Good
Copyright © Ooznest Ltd 2016 - All Rights Reserved