The Prusa i3 is one of the most popular printers out there, either a kit version, or a complete DIY Setup. This kit enables you to quick upgrade your Prusa i3 to the a Titan Aero Extruder. The E3D Titan Aero is a neat little package with the perforamance of a V6 Hotend and a Titan Extruder combined into one system.
Everything to upgrade your Prusa to the Titan Aero is included, even the stepper motor. An assembled version is also available.
Please read the below requirement to check this is compatible with your Prusa i3:
- 8mm Smooth Rods using LM8UU Bearings
- 45mm Rods spacing with rouhgly 15mm belt spacing
- One bearing on the top rod and two on the bottom. Vice versa will also work
This upgrade is not compatible with the Orignial MK2 / MK2A or MK3 as it is not compatible with the PINDA sensor used.
Note: HTML is not translated!
Rating: Bad Good
Copyright © Ooznest Ltd 2018 - All Rights Reserved