Much higher temperatures and better accuracy is achievable with a PT100 temperature sensor. PT100 sensors can measure up to and beyond 400ºC and are much more accurate than thermistors and thermocouples.
These are easily clamped in place using a grub screw on the new E3D v6 sensor block design.
A PT100 will usually require an amplifier board to make it compatible with your 3D printer controller.
The Ultimaker 2 uses a PT100 sensor, this sensor will allow you to easily connect your E3D Hotend to an Ultimaker 2 with no alterations.
Your Name:
Your Review:
Note: HTML is not translated!
Rating: Bad Good
A revolution is coming… one where our 2D thoughts are turned into 3D realities and where you have full control of your creative experiments, with a little help from an online expert community that loves to share what we do. Ooznest is a proud cog in that machine - supplying the 3D printing community with what they need to grow and thrive.
Copyright © Ooznest Ltd 2018 - All Rights Reserved