From the 25th - 28th September, some of the Ooznest team are at the TCT Show 2017. Due to this there will be some delays in answering phoncalls and emails. During this period the best way to contact us would be by email. However we promise to get around to everything, it just may take longer than usual. Thanks Ryan Lock - Ooznest.
The A4988 Stepper Motor Driver is the perfect choice for 3D printer applications, and is without a doubt the most commonly used. The A4988 has a maximum output of 35V at ±1.5A, with 5 step revolutions of full-step, half-step, quarter-step, eighth-step, and sixteenth-step. The built in potentiometer allows you to set the maximum current output giving a higher voltage than your Stepper Motor's rated voltage, thus allowing for a higher step rate. The A4988 offers thermal circuitry protection, this is done by interrupting the current to let the board cool if it gets to hot.
It is highly recommended that you use the supplied heat sink and Conductive Aluminium Sicker to keep the A4988 Stepper Motor Driver as cool as possible. In addition it is advisable to have a fan actively cooling the Stepper Driver.
What You Will Be Getting
- 1 x A4988 Stepper Motor Driver
- 1 x Heat Sink
- 1 x Conductive Aluminium Sticker
Note: HTML is not translated!
Rating: Bad Good
Copyright © Ooznest Ltd 2017 - All Rights Reserved